In this brief installment of the Ye Blacke Death build logs, I messed with rings, and installed other things.

My challenge, as I showed Lung over the weekend, was that the bottom bracket spindle that I have on this build is too short. I COULD just get a longer spindle, but what fun is THAT. So I frankenbuilt the drivetrain. I spent a lot of time, too much time, playing with chainrings. I started by pulling the middle and small rings off of the crankset that came ont he old Vista that became wrongBike(tm) but this led to the discovery that the chainring bolts were too long, even with a huge amount of spacers. And, additionally, one was stripped and took some effort to get it out. Then I went after the Campy cranks I had in the shop, pulled the two rings off of those to get at the shorter bolts, to use on the Vista cranks… but once I did so, and installed the assembly on the frame, I discovered the short spindle. So, off came the ring for the third time, and the Campy crank was reassembled, with a single 53 chainring. This went on fine, but the corresponding non-drive crank arm hit the frame. Through experimentation, I found that the Vista’s crank arm didn’t, so now i have a Campy right side and a Vista (Suntour) left side. Done!

i sure know my way around quickly pulling chainrings, between the Miche cranks and now these.

This is the Bobike seat that’s going on the front of Ye Blacke Death, right above the back of the front rack. It’s a trick little system. I MAY get a windshield for it, but we’ll see how that pans out. I set out this past weekend, on a Daddy/Wee Z day, to get some installation done on the project, and my intention was to get fenders, rack and seat up on there. Each gave me problems but I saw what needed to be done to solve them. The seat clamps to the stem, necessitating that tall Nitoo Techntronic stem, but I need to get the rack on first. The rack wants to go on after fenders, of course, so that made fenders the next in line.

I was installing in the carport, as an experiment while the cat was away. I put wee Z in the pack and Tole, and she was good for about an hour, so that was actually pretty AWESOME. It’s not the first time I’ve wrenched with her hanging out: I’ve done a number of projects upstairs on the back desk with her in the sandbox. That requires bringing the stand, the bike parts and all the tools upstairs, which is kind of a pain, so I wanted to try the carport this time.

You can see I got the fenders out, there. These are from Woody’s Fenders. Amazing build quality, hand-crafted goodness. I subsequently got them on the bike. Not complete, though. The rear needs to have an L-bracket drilled into the wood, and the front has a bigger issue: seating a front brake securely on the fork, on which the fender also hangs. I need a longer bolt. So there’s that. But progress all the same. You can kind of see, from this shot, some of how it’s coming together. Lung saw it a little farther along and up close.

Getting closer!

Be Sociable, Share!

• 

Follow this topic in the R3 Forum here!

Related posts:

1. Bike Build Process Log: Ye Blacke Death – Gamoh Go!
2. Bike Build Process Log: Ye Blacke Death – Rubber Hits Road
3. Bike Build Process Log: Ye Blacke Death – Over the Moon